The ST342S series Senyd sensor is a domestically developed dual axis 4-way 2-way tilt switch for component tilt angle measurement module. It adopts the RTU Modbus protocol and its internal core components are 100% domestically produced, including MCU processors MEMS tilt unit, power circuit, output circuit, etc. To manufacture domestically produced equipment and overcome technological barriers in independent research and development.

All products undergo calibration, temperature compensation, and long-term aging stability testing before leaving the factory. Each process is precise and rigorous, ensuring reliability under different working conditions and long-term use cycles; The measurement range is 0~± 90 °, with two sets of relay output circuits (normally open and normally closed contacts) built-in. When the inclination value is greater than the preset alarm threshold, a borderless contact relay signal (driving current 1A) will be output

A voltage signal (output voltage=power supply voltage) can be used to drive the solenoid valve to shut off the hydraulic system, buzzer, alarm light, etc., automatically warning workers of safe construction.

Equipped with computer debugging software, the alarm threshold is calibrated at the factory, and users can also set their own alarm angle threshold.